Fits 1967-68 with 1986-95 Mustang 5.0 bellhousing or scatter shiled and T-5, T-45, T-56, or Tremec transmission.
Installing a T-5 transmission in your 1967-68 Mustang? The easiest and best way to do this is to use the T-5 bellhousing, clutch fork and throw out bearing from your 1986 to 1995 donor 5.0 Mustang! This way there is no spacer plate to buy, saving you over $100.00 in the process! And with this new Cable Clutch Kit from Ron Morris Performance, you’ll also have the added benefit of a newer style cable operated clutch! No more binding! No more bent clutch rods! No more equalizer bar to transmit engine vibration to the chassis and interfere with your exhaust system! Just install your 1986 to 1993 or 1994 to 1995 bellhousing and T-5 transmission, make sure the cable will mount into the factory location on the bellhousing, clearing your exhaust system*, and the bottom is done! Attach the clutch quadrant to your existing clutch pedal (while it is still in the car!), install the firewall bracket and drill the hole for the cable! Hook the cable up and you’re done! Easy to follow instructions included with each kit! (*This Cable Clutch Kit works well with stock exhaust manifolds, HiPo exhaust manifolds, shorty headers, and some long tube headers.)

•Easy bolt-on installation
•Easier to install and less maintance than with hydraulic systems
•Compatable with both manual and power brakes
•Installs in about 90 minutes
•Limited Lifetime Warranty
•No drilling required. Uses existing clutch linkage hole in the firewall.
•For use with 86-95 Mustang 5.0 bellhousings or scatter shields and T-5 & Tremec Transmissions
•Smoother operation than stock mechanical linkage
•Comes with mounting hardware & instructions
•Works great with stock manifolds, Hi-Po manifolds, shorty headers, and some long tube headers
•See www.RonMorrisPerformance.com for more information